плагины для кс 1.6 хп
Dismantle поликлиновой a belt together with the tension device (has undressed the Generator ). Dismantle covers of a gear belt on both parties. Turn коленвал in ignition position in ВМТ the cylinder 1. Marks in a belt pulley коленвала and covers of a gear belt should coincide, the big apertures on fixing plates on pulleys of cam-shafts should be turned to each other to the engine centre. Unscrew from картера the gauge of the moment of ignition and instead of it screw in the special The tool «Fastening коленвала 3242». Slightly tighten. Dismantle a pulley поликлинового a belt коленвала , unscrew the bottom cover of a gear belt. Note a direction of movement of a gear belt for the subsequent installation. Keep the same direction of movement of the belt which was in the use. Loosen the a tension roller of a gear belt, remove a gear belt. Installation: the special tool «Fastening of a cam-shaft 3243» establish on fixing plates of cam-shafts. Loosen the bolts of pulleys of cam-shafts approximately only on three turns. Again dismantle the special tool 3243. Remove both pulleys of a cam-shaft from a cone. Use for this purpose nippers. Establish прихваты on an underside of a nave of a pulley of a gear belt; the bolt remains, as was (weakened on three turns). After end of preliminary works installation now begins: For carrying out of the further work now it is necessary to impose a new gear belt. At imposing of the belt which was in the use, consider a direction of its movement. Again establish on fixing plates of cam-shafts the special tool «Fastening of a cam-shaft 3243». Once again check up correctness of installation of the special tool. Pulleys of cam-shafts should be put on a cone so that they rotated on a shaft, but were not shaken (a bolt is screwed up manually). Now pull a gear belt (see in the head above). Tighten pulleys of cam-shafts with the inhaling moment on 30 Nanometers and then definitively tighten bolts on 1/2 turns (180 °). Remove the special tool.